Research Output
Fringing effects in re-entrant and Inverted re-entrant turnstile waveguide junctions using cylindrical resonators.
  One waveguide network is a 5-port turnstile junction consisting of three H-plane waveguides with a circular quarter wave long resonator on its axis, open circuited at one end and short circuited at the other. It is readily converted to a turnstile 3-port circulator by replacing the dielectric resonator by a gyromagnetic one and closing 2 of the 5 ports. Another network that may be reduced to a 3-port circulator is a 7 port turnstile junction containing a pair of similar coupled resonators or a half wave long arrangement open circuited at each end. The introduction of suitable symmetry planes in the latter two geometries suggests that all three have, in the absence of any fringing effects, the same centre frequency. In practice, however, this is not so. This paper employs an FE process to investigate this assumption in the cases of re-entrant and inverted re-entrant resonators. One conclusion of this work is that a FE or similar numerical tool is mandatory for the adjustment of such a degree-2 circuit.

  • Type:

    Article

  • Date:

    27 June 2011

  • Publication Status:

    Published

  • Publisher

    IET

  • DOI:

    10.1049/iet-map.2010.0393

  • ISSN:

    1751-8725

  • Library of Congress:

    TK Electrical engineering. Electronics Nuclear engineering

  • Dewey Decimal Classification:

    621.3 Electrical & electronic engineering

Citation

Helszajn, J., & Sharp, J. (2011). Fringing effects in re-entrant and Inverted re-entrant turnstile waveguide junctions using cylindrical resonators. IET microwaves, antennas & propagation, 5, 1109-1115. https://doi.org/10.1049/iet-map.2010.0393

Keywords

waveguide network; five-port turnstile junction; H-plane waveguides; turnstile threeport circulator; re-entrant and inverted re-entrant resonators;

Monthly Views:

Available Documents