Edinburgh Napier University

  Discontinuous dynamic recrystallisation (DDRX) is a well-known phenomenon playing a significant role in the high-temperature processing of metals, including industrial forming and severe plastic deformations. The ongoing discussion on the Zener–Hollomon (Z–H) parameter as a descriptor of materials’ propensity to DDRX and a measure of microstructure homogeneity leaves more questions than answers and prevents its practical application. Most of the existing DDRX models are continuous, and so the geometry and topology of real grain microstructures cannot be considered. The present study uses a fully discrete representation of polycrystalline aluminium alloys as 2D/3D Voronoi space tessellations corresponding to EBSD maps. Such tessellations are geometric realisations of combinatorial structures referred to as polytopal cell complexes. Combining discrete models with FEM LS-Dyna simulations of shock-wave propagation in AA1050 and AW5083 aluminium alloys makes it possible to estimate for the first time the contribution of DDRX to the final material microstructure inside adiabatic shear bands. It is shown that the increase of the initial fraction of high-angle grain boundaries, caused by preliminary deformation, significantly increases the spatial homogeneity and decreases the clustering of DDRX grains. The obtained results contradict the conventional assumption that the microstructures obtained by severe plastic deformation under quasi-static and dynamic deformation conditions are similar due to the similar value of the Z–H parameter: competition between the two recrystallisation mechanisms leads to almost unpredictable final grain structures inside share bands that require further comprehensive experimental studies. This agrees with experimental evidence for high material sensitivity to the Z–H parameter.