Research Output
Triboelectric Nanogenerator With Enhanced Performance via an Optimized Low Permittivity Substrate
  With electrical power generated from mechanical contact, triboelectric nanogenerators (TENGs) offer a promising route to realizing self-powered sensors. For effective usage, it is important to improve their limited power range (0.1–100 mW/cm 2 ) and this can be achieved by optimizing the output performance. Among the factors that confer higher performance are materials with a strong triboelectric effect together with low permittivity, but it is challenging to optimize both within a single material. This paper presents a solution to this challenge by optimizing a low permittivity substrate beneath the tribo-contact layer. Results are simulated over a range of substrate permittivities. The open circuit voltage is found to increase by a factor of 1.6 in moving from PVDF to the lower permittivity PTFE. Two TENG devices have been fabricated with 100μm PET and PTFE substrates to compare performance. The experiments confirm that lowering the substrate dielectric constant (i.e. PET to PTFE) raises the open circuit voltage in line with simulation predictions.

  • Type:

    Article

  • Date:

    30 August 2019

  • Publication Status:

    Published

  • Publisher

    Institute of Electrical and Electronics Engineers (IEEE)

  • DOI:

    10.1109/jsen.2019.2938605

  • Cross Ref:

    10.1109/jsen.2019.2938605

  • ISSN:

    1530-437X

  • Funders:

    Engineering and Physical Sciences Research Council

Citation

Min, G., Manjakkal, L., Mulvihill, D. M., & Dahiya, R. S. (2020). Triboelectric Nanogenerator With Enhanced Performance via an Optimized Low Permittivity Substrate. IEEE Sensors Journal, 20(13), 6856-6862. https://doi.org/10.1109/jsen.2019.2938605

Authors

Keywords

Triboelectric nanogenerator, self-powered sensors, simulation, permittivity, dielectric

Monthly Views:

Available Documents